FACTORY FEEDBACK - ENGLISH TRANSCRIPTION Source: Chinese chat screenshot supplied by the user on 2026-11-02. English issue: 2026-11-03. This is a translated transcription of the technical excerpts, not an original English chat screenshot. The Chinese source image remains in the earlier Chinese package. Greetings and acknowledgements are omitted here. SUPPLIER COMMENTS 1. Tooling for the grill is approximately RMB 40,000. It may be a little cheaper if a similar existing factory mould can be used. 2. The proposed lid design does not work. The engineer says that closing it would press down on the food, which is unreasonable. 3. There is also a surface-finish issue: most enamelling factories can make only one colour for this arrangement, either all white or all black. 4. Referring to the image, the supplier suggests removing the two indicated handles and extending/turning the lower wire upwards so it can be carried, like their bucket-style grill. 5. The supplier says the lower feature appears to be an air outlet. FORWARDED-MESSAGE CONTEXT The supplier said they would forward the engineer's original wording and ask for Mandarin because the original recording used a dialect. That recording and the factory's bucket-grill reference were not supplied in this chat. USER CLARIFICATION, 2026-11-02 The user explicitly confirmed: the legs should flip over and also serve as the handle. REV B DESIGN RESPONSE Increase lid rise to 85 mm and define nominal food clearance. Specify one white enamel colour on both sides of the bowl and lid. Use two supporting U-frames that flip up and meet as the carrying grip. Remove the separate bail and fixed lid-top handle. Clarify intended airflow as bottom intake and top exhaust; the supplier's outlet comment is a source observation, not the adopted airflow specification. Keep the tooling figure as an unconfirmed estimate; obtain actual existing-mould data before deciding on reuse.